🚀 go-pugleaf

 In article <819133100_OASIS_@tequila.demon.co.uk>
  gary@tequila.demon.co.uk (Gary Cleghorn) said:-

>Where do i change the baud rate to 150? I understand what you're
>getting at but i thought this could only be set in the ST's MFP.PRG 
>i'm using SCC.PRG which is for the Falcon .
>What programs are you using and what are the settings?

DRVIN and SCC. I can't remember the config settings for SCC. I got 'em out of
AtariWorld. The docs aren't much help, are they? Great program, shame about the
German instructions.

To set the baud rate you want:
 
# Attach the SLIP driver to the serial port
#      if  port 0 slip dev buff mru  baud
#      --- ---- - ---- --- ---- ---  ----
attach asy AUX: 0 PPP sl0 32767 1500 110

This sets it to 38400. See HSMODEM docs.

Then use the MODEM CPX to set your baud rate to 110 as well. Don't foget to
'save' the setting. 
This does appear to be important. If it's not set, it doesn't seem to work.

Ignore the message NOS gives when connecting about an unkown baud rate.
It doesn't know what it's talking about.

Hope this helps.

Gary.

__

 ---------------------------------------------------------------------------  
 Gary Priest           gary@the-gap.demon.co.uk          Southampton,England
 ---------------------------------------------------------------------------