🚀 go-pugleaf

In article <9507090948.AA0033a@stokes.demon.co.uk> Philip Stokes <phil@stokes.demon.co.uk> writes:

> work with my machine configuration as reported to him. A number of
> phone calls later, after which we had established that the make, model
> and revision numbers of my hard drive were on C='s approved list, I am
> currently awaiting delivery of a Viper II 50MHz 68030.

I hope your will be *slightly* better constructed than mine..... It had
two faults major faults which I have so far rectified.

 1) There was a solder bridge shorting two pins on the edge connector
 2) The real time clock refused to work.. after checking the board, I
    noticed that one of the diodes had been soldered into the board the
    wrong way around.

I could have just been unlucky with a 'friday afternoon' board, but
needless to say, I'm none to impressed with DKB's quality control.

Other than that, it's not too bad =o)

Robin.

-- 
  Robin Grzasko                            E-Mail: robin@robski.demon.co.uk