🚀 go-pugleaf

In article <uzIM3AAundgxEwKF@gokart.demon.co.uk>
           joe.brand@gokart.demon.co.uk "joe.brand" writes:

> I have an Intel Endeavour motherboard.
> 
> Whenever I try to use a PCI slot for a new PCI graphics card, the board
> gives out 1 long beep followed by 2 short beeps. It continues to go
> through the load up process, but there is no display on the screen. 
> 
> The board works O.K with all ISA slots in use, but no PCI cards in use. 
> The PCI graphics card works in another machine.
> I have tried another working PCI graphics card, withh same effect.
> I have taken out all the ISA boards but fault persists.
> Any help please.
> 
> -- 
> joe.brand
> 

I've had this problem too, on 3 Endeavour Boards.

1) Check to make sure you don't have your IDE cable on the jumpers the
   wrong way round.

2) If not 1, clear CMOS via moving DIP 4 on to clear CMOS then put it off.

If this doen't work, e-mail me..

The fact that it's happened to me on 3 different boards makes me think it
can't be too big a problem...just an annoying one.
-- 
David Longley