🚀 go-pugleaf

$B7DXfBg3X$N3yED$H?=$7$^$9!#(B

In article <KATASE.92Oct5172412@sistgw.cc.sist.ac.jp>, katase@cc.sist.ac.jp (Yoshinori Katase) writes:

 > $B$=$3$G<ALd$J$N$G$9!#(B
 > SCSI ID$B$H(B/dev/sd$B$NHV9f$NBP1~$O$I$&$d$C$F$H$k$N$G$7$g$&!#(B

 > $B:#!"$3$N(BIPC$B$K$O(B
 > sd3$B$,(BID 0$B$G!"(Bsd2$B$,(BID 2$B$G7Q$C$F$$$^$9$,!"(Bsd0$B$r(BID 3$B$G7R$0$K$O$I$&$9$k$N$G$7(B$B$g$&!#(B

kernel$B$r(Bconfig$B$9$k$H$-$K7h$a$i$l$F$$$k$N$G$O$J$$$G$7$g$&$+!#(B

IPC$B$H(B$B$$$&$3$H$G$9$N$G!"(Bsun4c$B%"!<%-%F%/%A%c$@$H$7$F!"(B
/sys/sun4c/conf/GENERIC$B$r8+$^(B$B$9$H!"(B196$B9TL\$"$?$j$+$i(B

#
# The following section describes SCSI device unit assignments.
#
scsibus0 at esp				# declare first scsi bus
disk sd0 at scsibus0 target 3 lun 0	# first hard SCSI disk
disk sd1 at scsibus0 target 1 lun 0	# second hard SCSI disk
disk sd2 at scsibus0 target 2 lun 0	# third hard SCSI disk
disk sd3 at scsibus0 target 0 lun 0	# fourth hard SCSI disk
tape st0 at scsibus0 target 4 lun 0	# first SCSI tape
tape st1 at scsibus0 target 5 lun 0	# second SCSI tape
disk sr0 at scsibus0 target 6 lun 0	# CD-ROM device

$B$H$$$&5-=R$,$"$j$^$9!#$3$3$N(Btarget ?$B$H$$$&(B$B$N$,(BSCSI ID$B$G$O$J$$$G$7$g$&(B
$B$+!#(B

$B0JA0(BSun$B=c@5$N30$E$1%G%#%9%/$rGc$C$?$H$-(B$B$K$D$$$F$-$?%^%K%e%"%k$K$O3F%"!<(B
$B%-%F%/%A%c$4$H$N(BSCSIID$B$H%G%P%$%9L>$NBP(B$B1~I=$,$"$C$?$N$G$9$,!#(B
--
	$B3yED(B $BIRG7(B		kamada@doi.cs.keio.ac.jp