🚀 go-pugleaf

On Tue, 06 Jan 1998 18:08:03 +0100, Brice et Marie Caussanel
<JM.Caussanel@wanadoo.fr> wrote:
<snip>
>j�ai une Logitech s�rie (qui devrait bien tourner). La sourie est sur le 
>port COM 1.
>Sur le port COM 2, j�ai mon Modem (US ROBOTICS Flash). Idem cela ne 
>marche pas.
<snip>
Inverse ta souris et ton modem.
N.B.: Je suis s�rieux, il y a eu une note de microsoft qui indiquait
un conflit dans un config entre la souris et le modem, et la solution
�tait d'inverser. donc dans ton cas essaye souris sur COM2.

VOICI le document:

Mouse stops working after the installation of my Modem with Windows 95

     If you are using a Logitech Mouse model M-M30 or cc-93-9f on
COM1, and you installed a new modem on COM2,
     the modem may stop working with Windows 95. This information does
not apply to a modem that was previously
     working, unless you installed one of the above Logitech Mouses.
The best solution is to change the COM port of the
     Logicode modem to COM1 and connect the Mouse to COM2. However,
before changing the modem to COM1, you
     must first disable your internal COM1 in your computer's CMOS
setup or with a jumper/switch on your I/O card. More
     complete information about this problem is available on Microsoft
Knowledge Base at: 

     http://www.microsoft.com/ kb/articles/q136/7/90.htm

     Please note that other models have also been reported to cause
this same problem.

If you see a "!" in my E-Mail adress, remove it !
S'il y a un "!" dans mon adresse E-Mail enlevez le !