🚀 go-pugleaf

I have this habit of starting lines in for loops with tabs.  Tabs
are special by default in bash, and I haven't done anything to
change this for me.

In any case, it appears that if I start bash, type some stuff including
a tab, and then exit bash, my tty modes are different.  Since I am
still using BSD csh with command completion as my standard shell,
this is a problem, as it screws up command completion printing.

The following script session shows the behavior:

Script started on Fri Nov 10 15:24:02 1989
icky 1>stty everything
new tty(ascii) speed 9600 baud, 59 rows, 80 columns
non parity, -raw -nl echo -lcase -tandem tabs -cbreak 
crt: (crtbs crterase crtkill ctlecho) -tostop 
-tilde -flusho -mdmbuf -litout -pass8 -nohang 
-pendin -decctlq -noflsh 
erase  kill   werase rprnt  flush  lnext  susp   intr   quit   stop   eof
^H     ^U     ^W     ^R     ^O     ^V     ^Z/^Y  ^C     ^\     ^S/^Q  ^D     
icky 2>./bash
bash$ pwd      <--- that ^G is from my TAB
/mnt/dce/Src/bash-1.04
bash$ icky 3>stty everything
new tty(ascii) speed 9600 baud, 59 rows, 80 columns
non parity, -raw -nl echo -lcase -tandem tabs -cbreak 
-crtbs -crterase -crtkill -ctlecho -prterase -tostop 
-tilde -flusho -mdmbuf -litout -pass8 -nohang 
-pendin -decctlq -noflsh 
erase  kill   werase rprnt  flush  lnext  susp   intr   quit   stop   eof
^H     ^U     ^W     ^R     ^O     ^V     ^Z/^Y  ^C     ^\     ^S/^Q  ^D     
icky 4>
script done on Fri Nov 10 15:24:30 1989

Basically, crt mode and prterase has been turned off.
-- 
David Elliott
dce@sony.com | ...!{uunet,mips}!sonyusa!dce
(408)944-4073
"You can lead a robot to water, but you can not make him compute."