🚀 go-pugleaf

	Since porting version 18.52 to our VAX (8550 running V4.6), I
have had little or no problems.  I even managed to work around a flow-
control problem with most of our main-lab terminals.  All of a sudden
though, the cursor control keys for some of our terminals (HDS200's)
have stopped working.  I only noticed this today (see date, above),
so I'm not sure exactly what's going on.  After a little fiddling,
here's what I discovered:

	 - invoking emacs does what it's supposed to, including loading
	the .emacs file
	 - cursor control keys act as if terminal-specific file (vt100.el)
	has not been loaded, even though it has
	 - if emacs is invoked from same terminal after SET HOST 0 is
	executed, cursor control keys (and everything else) work fine

Any ideas?

							Thanks,
							 Mike
__________________________________________________________________________
|        THE InterNet address> davism@kcgl1.eng.ohio-state.edu           |
--------------------------------------------------------------------------
|       These are my thoughts and do not necessarily reflect those of    |
|The Ohio State University, IRCC-Facilities Management, Koffolt Computer |
|Graphics Lab, The OSU Chemical Engineering Department, or anyone else...|
|************************************************************************|
|         "Daddy, Daddy!!  Why's Mommy running across the field?"        |
|                        "Shut up Son, and reload."                      |
--------------------------------------------------------------------------