🚀 go-pugleaf

In article <8902090003.AA00499@umn-cs.cs.umn.edu> sewall@UMN-CS.CS.UMN.EDU ("Scott Sewall") writes:
>I'm installing GNU C v1.32 on a sun386i running SunOS v4.0.1.
>The make fails on stage1. Below is a log of the make. Any help
>would be appreciated.
>
>Scott
>
>	...........mucho deleto......
>
>ld: stage1/gnulib: warning: archive has no table of contents; add one using 'ranlib'
>ld: stage1/gnulib(__.SYMDEF): bad magic number
>*** Error code 1
>make: Fatal error: Command failed for target `gcc'
>gandalf% 

You must have had a gnulib for another architecture lying around when
you did the make. You should always remove it before building for a new
architecture. I had this problem also. After you've installed the
complier, and done a 'make clean' do an 'rm gnulib' to get rid of the
old GNU library before building for a new architecture.

						AWF
-----------------------------------------------------------------------------
Internet: feigin@tcgould.tn.cornell.edu		Adam Feigin
Bitnet: feigin@crnlthry				Workstation Consultant
UUCP: {backbones}!cornell!batcomputer!feigin	Cornell National Supercomputer
MaBell: (607) 255-3985				Facility, Visualization Group

		"Sometimes a little brain damage can help"

-----------------------------------------------------------------------------
Internet: feigin@tcgould.tn.cornell.edu		Adam Feigin
Bitnet: feigin@crnlthry				Workstation Consultant
UUCP: {backbones}!cornell!batcomputer!feigin	Cornell National Supercomputer