🚀 go-pugleaf

In article <ddkilzer.825284447@tbp.eng.iastate.edu>,
David D Kilzer <ddkilzer@iastate.edu> wrote:
>lew@omocha.tay.dec.com (Paul Lew) writes:
>
>>I built gcc-2.7.2 on my HP-UX 9.05 system (without gas) successfuly
>>but I need debugging information so I rebuilt it with gas but failed.
>>I did the following steps:
>
>>(1) built and installed GAS (from binutils-2.6) in /usr/local/bin/as
>>(2) build the target directory tree:
>>	$ make install-dir
>>(3) setup a symbolic link:
>>	$ ln -s /usr/local/bin/as
>>		/usr/local/lib/gcc-lib/hppa1.1-hp-hpux9.05/2.7.2/as
>
>I believe the recommended procedure is to make a soft link of as into
>your gcc-2.7.2 build directory.

I too would recommend that you make the link or symlink into the gcc build
directory.  Once you have it in the main gcc build directory, you can

	make bootstrap LANGUAGES="whatever" BOOT_CFLAGS="whatever"

and the as in the main build directory will get copied automatically into
the stage1 & stage2 subdirectories.

>  2. You need to compile GNU ld on your system as well.  (I know the
>     docs say you don't have to, but sometimes it's just easier to use
>     it anyway.)

GNU ld isn't supported under HP-UX {9,10} on the PA RISC.

Tim
-- 
Tim Mooney                              mooney@toons.cc.ndsu.nodak.edu
Information Technology Services         (701) 231-1076 (Voice)
Room 242-J6, IACC Bldg.                 (701) 231-8541 (FAX)
North Dakota State University, Fargo, ND 58105