🚀 go-pugleaf

In article <199511231717.KAA04627@rintintin.colorado.edu>,
Coy Toavs <toavs@rintintin.colorado.edu> wrote:
>
>I can't seem to get it to build.
>
>does ./congifure --with-gnu-as OK
>but on the next step 'make LANGUAGE=c' it dies with errors.
>
>any body made is successfully? if so how?
>... also I only have the crippled basic C compiler from HP
>I don't have the C/ANSI one.

I've built gcc-2.7.0 and gcc-2.7.1 (with various patches, so far about
10 times or so) on HP-UX 10.01 (9000/809 aka K-100) w/out any problems
whatsoever. I use gas from the binutils-2.5.8u6 from jaguar.cs.utah.edu.
I just built the latest with gas from binutils-2.6, but haven't tested
it extensively yet -- the installation went fine though.

I haven't bothered installing HP ANSI C yet, so I'm using the same setup
you are. Could you include the error messages you're getting?

One thing you could do is to get the pre-built gcc-2.6.3 from jaguar ftp
archive and then build 2.7.1 using GCC itself instead of HP crippled cc
and see how far you go with that.

Here's my usual build script (assuming I'm building in source dir):
    
    % ./configure --with-gnu-as 
    % gnumake install-dir
    % NOW COPY GAS (as) to $prefix/lib/gcc-lib/hppa1.1-hp-hpux10.01/2.7.1
    % (gnumake CC=gcc LANGUAGES=c && gnumake stage1 \
	&& gnumake CC="stage1/xgcc -Bstage1/" CFLAGS="-g -O") >& make.log
    % go to lunch.
    % gnumake CC="stage1/xgcc -Bstage1/" install >& install.log

Cc: gnu.gcc.help,
    Coy Toavs <toavs@rintintin.colorado.edu>