🚀 go-pugleaf

Questions 1 & 3 apply to gas960, while question 2 applies to gcc960.  I
am running these tools on DOS.

I am just beginning to work with the EV80960SX board using GNU/960 tools
2.0.1 for DOS.  I have three problems.

1. The Blue release notes that came with GNU/960 make two references to
G960SETX.  The first is on page 19.  The second is on page 77, 10.1.6.
Page 19 refers the reader to the man pages, while page 77/78 says that a man
page on G960SETX, found at the end of the release notes should be inserted
into the manual.  I cannot find any man pages on G960SETX at all.  Where
can I get this documentation on G960SETX?

2. Is there a way to re-direct te error output of the tools, most importantly,
gas960 and gcc960, to a file instead of the console in DOS?

3. Working with gas960, I want to define some structure templates.  Most
all assemblers give you some way to do this.  I beleive MASM for the x86
family has the "struct" psuedo-op.  In some assemblers you must simply
set "org" to 0 and define the struct members, thus associating offsets with
the labels.  gas960 doesn't seem to have an explicit op for this, nor can
I use .org repeated times, since gas960 doesn't seem to want to let me reset
the org to 0 multiple times.

Any help is appreciated.

-Sam

--
Sam Bauer	|	Hewlett Packard Co.,   
(719)-531-4460	|	Network Test Division   
smb@col.hp.com  |       Colorado Springs,CO