🚀 go-pugleaf

olsenc@carson.u.washington.edu (Clint Olsen) writes:

>Hello:

>According to the INSTALL file included with gcc2.3.1, the instructions
>still state that:

>"the -g option will not work on HP-UX 8.0"

>The only way to get around this they mentioned was to use the (--gas)?
>option when compiling gcc.  This is not supported on anything other
>than the HPPA architecture.

>As I see it, the oddball HP, who just loves to do things its own way,
>is keeping me from using a nice piece of software.

Not really. Just get GAS 1.36 from jaguar.cs.utah.edu in the /dist
directory (or geod.emr.ca in /pub/hp), file name pa-gas.u3.tar.Z.
Compile this with the HP C compiler. Then get gcc-2.3.1.u2.tar.Z
from same sites and compile them using 

	configure hp700-hpux --with-gnu-as --with-gnu-ld

or derivatives (hppa1.1-hpux, hppa1.0-hpux, etc).
	Finally get the GDB 4.6 patches from same site again, file
pa-gdb-4.6.tar.Z, and the GNU release of GDB 4.6 from geod.emr.ca 
(in /pub/gnu dir) or any other GNU site and compile it.
	You will then have a fully functioning set of GNU tools.


>-----------------------------------------------------------------------
>Clint Olsen 
>olsenc@u.washington.edu
>-----------------------------------------------------------------------
--
Pierre Mathieu                          "We have seen the enemy,
Geodetic Survey of Canada                  and the enemy is us."
Ottawa, Canada                                                Pogo
Internet: mathieu@geod.emr.ca