🚀 go-pugleaf

On a Sun Sparc running SunOS 4.1.1, I have the following C++ program
(compiled with g++ 2.0).

     1  #include <stdio.h>
     2
     3  main()
     4  {
     5    int i;
     6    for (i=0; i<10; i++)
     7      {
     8        if (i==i)
     9          printf("%d\n",i);
    10      }
    11    printf("Aha! %d\n",i);
    12  }

In gdb 4.5, I can set a breakpoint at line 11 with "break 11". When I
run the program, it prints 0 through 9 and then breaks. This is
correct behavior. 

Now I have this program:

     1  #include <stdio.h>
     2
     3  main()
     4  {
     5    int i;
     6    for (i=0; i<10; i++)
     7      if (i==i)
     8        printf("%d\n",i);
     9    printf("Aha! %d\n",i);
    10  }

I just took out the braces for the "for" loop. I would like once again
to set a break point before printing "Aha!", so I say, "break 9".
However, when I run the program, it prints 0 then breaks. When I hit
"c", it prints 1 and then breaks. This continues as if gdb couldn't
decide if the "Aha!" line was part of the loop or not (i.e., it breaks
as if it were part, but does not execute it after I hit "c"). After
finishing the count from 0 to 9, breaking after every number, it
finally prints the "Aha!".

Am I doing something wrong? (besides using older versions of the compiler
and gdb?) 

Kevin

--
Kevin Kells <kells@iis.ethz.ch>         telephone: +41-1-256-5746
Integrated Systems Laboratory, ETH-Zentrum, CH-8092 Zurich, Switzerland