How to use A4 with GS 2.4.1 and HP III ?

Article View: gnu.ghostscript.bug

Article #158

Back to gnu.ghostscript.bug Previous Next

#158

From: Niels Skov Olsen
Date: Thu, 30 Jul 1992 13:02

17 lines
1058 bytes

When I print a page on my LJ III the top is clipped and the page seems
too short. The only device installed in the makefile is ljet3.dev.
I have tried to adjust the page size and margin settings for this
device in gdevjet.c but with no luck. I made following changes:

	#define WIDTH_10THS 84       (was 85)
	#define HEIGHT_10THS 117     (was 110)

This change made the page a little longer. For the gs_ljet3_device I 
tried increasing the 4 margin settings, but that didn't seem to have
any effect on the output.

I built GS under Linux with gcc 2.2.2 with no problems at all.

Any ideas anyone ?

Niels

Technical Details

Message-ID: <1992Jul30.130256.11668@odin.diku.dk>

Path: arc1-ca.pugleaf.net!sparky!uunet!cis.ohio-state.edu!diku.dk!dingbat

Show Full Headers

Complete Article Headers

Newsgroups: gnu.ghostscript.bug
Path: arc1-ca.pugleaf.net!sparky!uunet!cis.ohio-state.edu!diku.dk!dingbat
From: dingbat@diku.dk (Niels Skov Olsen)
Subject: How to use A4 with GS 2.4.1 and HP III ?
Message-ID: <1992Jul30.130256.11668@odin.diku.dk>
Sender: gnulists@ai.mit.edu
Organization: Department of Computer Science, U of Copenhagen
Distribution: gnu
Date: Thu, 30 Jul 1992 13:02:56 GMT
Approved: bug-ghostscript@prep.ai.mit.edu
Lines: 19