🚀 go-pugleaf

Did you try disable the PNP mode at DOS mode by using "3c9x5cfg". Then note
down the I/O port and IRQ. And set the same at LINUX.

Gilberto Alemanni wrote:

> Hi,
>
> I have installed a ethernet board 3com905B-TXNM on an
> ASUS P3B-F motherboard. When I boot under Win98 there
> is no problem, the board is well recognised and  works
> fine.
>
> When I boot under RedHat 6.0 there is a trouble: the
> board is recognized , but the IRQ is set to 0:
>
> From dmesg:
>
> eth0: 3Com 3c905B Cyclone 100baseTx at 0xd000,  00:50:04:a8:ff:3e, IRQ 0
>  *** Warning: IRQ 0 is unlikely to work! ***
>
> when I try to set up the interface with ifconfig eth0 up,
> I get the message:
>
> SIOCSIFFLAGS: Ressource temporarly not aviable
>
> I tried in the BIOS setup to force to IRQ 11 the PCI slot
> where the board is installed, it didn't solve the problem.
>
> Can anyone help me ? Thanks.
>
> Regards
>
>                         Gilberto.
>
> - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
> ALEMANNI Gilberto
> IPHE - Universit� de Lausanne
> CH-1015 Lausanne
> Phone : (++4121)6923736, (++4122)7626965
> Fax   : (++4121)6923605
> mailto:gilberto.alemanni@iphe.unil.ch
> - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
> " The man is the only male which beats its female. one
>   thus concludes that the man is the most brutal of the
>   males... unless the woman is, from all females, the
>   most unbearable. "            George COURTELINE

--
         __                   _  _         _  _         __
  _  _  (  )  _  _       ___ ( \/ )   ___ ( )( ) _  _  / _)
 ( \/ ) /__\ ( \( ) _   / __) \  /   (  _) )()( ( \( )( (/\
  \  / (_)(_) )  ( /_)  \__ \(__/     ) _) \__/  )  (  \__/
 (__/        (_)\_)     (___/        (_)        (_)\_)