Re: RS-232 problem

Article View: mod.telecom

Article #317

#317

From: Bob Bickford
Date: Sun, 09 Mar 1986 04:02

14 lines
1389 bytes

   Methinks you should not tie pins 1 and 7 together.  Just leave pin 1
completely out of the connection; it's only a frame ground and if you're
in the same building you don't need it.  We don't use it!

   Most T-switches do *not* switch the pin #1 connection, so there may
be the source of the trouble:  they're always tied together.

   The resistors should go to a 12v reference, not to ground, although
ground will work with many receiver IC's.  I would expect there is
already a resistor in the interface PCB, going to 12v, and if you
added one to ground at the switch you'd get a tendency to float to 6v,
maybe leading to more noise than you have now.  (assuming you use the
same value, namely 10K ohms)

Technical Details

Message-ID: <8603110520.AA05941@ucbvax.berkeley.edu>

Path: arc1-ca.pugleaf.net!utzoo!watmath!clyde!burl!ulysses!ucbvax!well.UUCP!rab

References: <8603060705.AA05792@ucbvax.berkeley.edu>

Show Full Headers

Complete Article Headers

Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Posting-Version: version B 2.10.3 4.3bsd-beta 6/6/85; site ucbvax.BERKELEY.EDU
Path: arc1-ca.pugleaf.net!utzoo!watmath!clyde!burl!ulysses!ucbvax!well.UUCP!rab
From: rab@WELL.UUCP (Bob Bickford)
Newsgroups: mod.telecom
Subject: Re: RS-232 problem
Message-ID: <8603110520.AA05941@ucbvax.berkeley.edu>
Date: Sat, 8-Mar-86 23:02:16 EST
Article-I.D.: ucbvax.8603110520.AA05941
Posted: Sat Mar  8 23:02:16 1986
Date-Received: Wed, 12-Mar-86 04:49:46 EST
References: <8603060705.AA05792@ucbvax.berkeley.edu>
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 14
Approved: telecom@xx.lcs.mit.edu

Reply to Parent Message