Thread View: net.auto.tech
2 messages
2 total messages
Started by Sesh Murthy
Sun, 03 Nov 1985 19:39
Noise while turning left
Author: Sesh Murthy
Date: Sun, 03 Nov 1985 19:39
Date: Sun, 03 Nov 1985 19:39
11 lines
973 bytes
973 bytes
I have a 1980 VW dasher(diesel if that matters) that makes a lot of noise when I bear left on a curve (even if the curvature is very low) but makes much less noise when I go straight or turn right. THis is noticeable only at speeds above 30 mph. The car has 87000 miles on it. ANy suggestions about possible causes and solutions would be appreciated. Sesh -- uucp: seismo!rochester!cmu-ri-leg!ssm arpa: ssm@cmu-ri-leg
Re: Noise while turning left
Author: kitten
Date: Thu, 07 Nov 1985 01:45
Date: Thu, 07 Nov 1985 01:45
21 lines
1686 bytes
1686 bytes
> I have a 1980 VW dasher(diesel if that matters) that makes a lot of noise when
> I bear left on a curve (even if the curvature is very low) but makes much
> less noise when I go straight or turn right. THis is noticeable only at
> speeds above 30 mph. The car has 87000 miles on it.
>
> ANy suggestions about possible causes and solutions would be appreciated.
> Sesh
**
For what it's worth, I had a similar problem on my 74 Mustang II. I experienced
noise on turns, nobody seemed to be able to figure it out until the car was
put up on a rack. It turns out the bozos who had replaced the starter (a FORD
dealer, of course) had failed to use washers (lock washers???) and two of the
three bolts were missing, with the third loose. The starter was flapping
around, and when starting, didn't always engage, just made a clattering
noise, as well as the noise when turning. This may not be the cause of
your problem, but it's worth a check.
{ucbvax!hplabs | allegra!nbires | decvax!noao | harpo!seismo | ihnp4!noao}
!hao!kitten
CSNET: kitten@NCAR ARPA: kitten%ncar@CSNET-RELAY
Thread Navigation
This is a paginated view of messages in the thread with full content displayed inline.
Messages are displayed in chronological order, with the original post highlighted in green.
Use pagination controls to navigate through all messages in large threads.
Back to All Threads