Article View: net.decus
Article #137vt220 help
From: adm
Date: Tue, 09 Apr 1985 14:28
Date: Tue, 09 Apr 1985 14:28
16 lines
1301 bytes
1301 bytes
I have a vt220 which I run in VT100 mode most of the time. I do however have a couple of programs that will only run on a VT52. At the present time a run a short program to software switch from vt100 mode to vt52 mode, This works fine, but when I want to switch back to vt100 mode I can't. Has anyone found an escape sequence that will permit you to switch from vt52 mode to vt100 mode or even to vt220 mode without reseting the terminal??? I have check the vt220 programmers guide but have not found a solution. tnx Gary W. Sanders (N8EMR) ihnp4!cbnap!gws AT&T Bell Labs (Columbus,Ohio)
Technical Details
Message-ID:
<3087@cbneb.UUCP>Path:
arc1-ca.pugleaf.net!utzoo!linus!philabs!cmcl2!seismo!harvard!talcott!panda!genrad!decvax!bellcore!sabre!zeta!epsilon!gamma!ulysses!mhuxr!ihnp4!cbosgd!cbsck!cbneb!admShow Full Headers
Complete Article Headers
Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Posting-Version: version B 2.10.1 6/24/83; site cbneb.UUCP Path: arc1-ca.pugleaf.net!utzoo!linus!philabs!cmcl2!seismo!harvard!talcott!panda!genrad!decvax!bellcore!sabre!zeta!epsilon!gamma!ulysses!mhuxr!ihnp4!cbosgd!cbsck!cbneb!adm From: adm@cbneb.UUCP Newsgroups: net.decus Subject: vt220 help Message-ID: <3087@cbneb.UUCP> Date: Tue, 9-Apr-85 09:28:52 EST Article-I.D.: cbneb.3087 Posted: Tue Apr 9 09:28:52 1985 Date-Received: Sat, 13-Apr-85 14:55:20 EST Sender: adm@cbneb.UUCP Organization: AT&T Bell Laboratories, Columbus, OHIO Lines: 18 Nf-ID: #N:cbnap:12600005:000:613 Nf-From: cbnap!gws Apr 9 07:44:00 1985