3-COM boards and Delni's

Thread View: net.lan

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Lester Waters PCSG Mon, 23 Sep 1985 15:20

#881

Author: Lester Waters PCSG
Date: Mon, 23 Sep 1985 15:20

23 lines
1304 bytes

	The default factory (except for the connector type) settings
for the half-size 3-COM boards are sufficient for them to operate with
DELNIs. We have a number of DELNIs and 3-COM cards (new and old)
installed here and have not had any problems. In the upper right corner
of the board, there is a 7-lead jumpber block. Move the jumper block up
from the BNC position the the DIX position. This will enable the use
of the DB-15 connector (and disable the BNC thin ethernet connector).

			Good luck!

				Lester Waters
				...!decvax!decwrl!dec-rhea!dec-karnac!waters


--------------------

Please note that this mail message is likely to be incomplete.
The sender aborted the transmission.

	rhea::MAILER-DAEMON

--------------------

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads