🚀 go-pugleaf

I am trying to fill out the control functions for the VT52 emulator on the
Atari 520ST desktop.  It is more than a straight VT52, since I have managed
to figure out the following:

	Sequence	Function		Sequence	Function
	========	========		========	========
	ESC A		Cursor up		ESC b_		Set char color
	ESC B		Cursor down		ESC c_		Backgrnd color
	ESC C		Cursor right		ESC d		Clear to BOS
	ESC D		Cursor left		ESC e		Turn on cursor
	ESC E		Clear screen		ESC f		Turn off cursor
	ESC H		Home cursor		ESC k		Home cursor
	ESC I		Insert line (here)	ESC l		Clear line
	ESC J		Clear to EOS		ESC o		Clear to BOL
	ESC K		Clear to EOL		ESC p		Inverse video
	ESC L		Insert line above	ESC q		Normal video
	ESC M		Delete line
	ESC Y__		VT52 Direct cursor addressing.  Last 2 are address.

	where: BOL, EOL, BOS, EOS are beginning of line, end of line, beginning
		of screen and end of screen respectively.  An underline is
		used to represent a variable argument character.

	The ESC b and ESC c sequences are followed by a color selection byte
	where the last 2 or 4 bits (depending upon your screen mode) select
	the color.  Default in 4 color mode is: 0 white, 1 red, 2 green and
	3 black.  I assume with black and white, you select with 1 bit.  NOTE
	that you can hide characters by setting the color of the char and it's
	background the same.

	Tabs work and seem to be hard wired every 8 columns.

	I haven't been able to find character insert or delete functions.

This was discovered by trial and error in local mode (HALF duplex).  Can anyone
verify and/or add to this?


					Rand Huntzinger