🚀 go-pugleaf

> To put in another graphics board you must first disable your present board. To
> do this you remove a 74LS00 chip located on the bottom middle of the graphics
> board.  It is above where the +5 volts and ground wire connect. In newer
> machines it is in a socket on older ones it is soldered in. NOTE this will
> void your warranty if you do it yourself! After removing the chip then pins 7&6
> must be jumpered together and 3,8,11,14 must all be tied together.  We got
> this fix directly from AT&T. We just bought 300 of these units and some will be
> modified.
> 
> All the usual disclaimers, ect...
> 
> Paul L. Marcuzzo
> Penn State University
> 
>      

Paul,

What monitor are you are using with your modified AT&T pc6300??
(I would have sent directly to you but I don't know how to mail to BITNET)

What I really want to do is use an ega card in my PC6300
(doing the modification you did) along with the AT&T color monitor
I already have. My problem is that since the AT&T color monitor has
a non standard plug, I have been unable to find an ega board
I could plug it into.

Any ideas would be greatly appreciated.

       Vern Bradner
       ihnp4!mhuxi!v1b