🚀 go-pugleaf

    We're setting up a PC6300 as a small file server, and have been 
considering two different angles.  We could dive right in and get the biggest 
drive we can find, but it seems the smaller drives have become such a 
commodity item that the cost per bit isn't necessarily lower for the higher 
capacity units, as used to be the rule.  So, at least for now, we're opting 
for putting a number of smaller, cheaper 10 and 20 Mb drives on.  The 
redundancy is nice to have, too.  

    To get to the point, we've got two 10 Mb and one 20 Mb drives running off 
two of AT&T's HDU Controllers.  Well, not running, really.  We can get the 
switch settings right to allow the power up diagnostics to tell us that there 
are three drives out there, but DOS (MS 2.11) fails to boot.  Several calls 
to ATTIS's hotline failed to help us much.  We've got version 1.21 ROM,s and 
all three HDU's are AT&T issue, collected from other PC6300 hard disk 
systems.  Has anyone out there had any luck with this type of configuration?  
We did find that we had to cut an I/O address jumper to get the second 
controller's disk to be found, and that made sense to us, but the DIPswitch 
table in the AT&T hardware reference manual is unfathomable.  We've yet to 
try 1.43 ROMS, but the hotline made no point of mentioning it.  Any ideas?


------------------------------------------------------------------
"Thunder is good, thunder is impressive;
 but it is lightning that does the work."  Mark Twain (1835-1910)
------------------------------------------------------------------

David T. Punia, Dept. of Computer Science & Electrical Engineering
The University of Vermont, Burlington, VT   05405-0156  
802-656-3330

USENET --> ....!decvax!dartvax!uvm-gen!punia
CSNET ---> punia@uvm  
OTHERNETS ----> punia%uvm@csnet-relay