xenix with the adaptek rll controller

Article View: net.micro.pc

Article #7284

#7284

From: nasser
Date: Wed, 16 Jul 1986 07:06

23 lines
1330 bytes

i have been having problems with booting from xenix
on the new adaptek 2070 rll controller.  the installation
process goes without a hitch, but when i boot from
the hard disk i get a bunch of error messages
including "not a directory," "/boot not found,"
and "stage 1 boot failure."  i can still boot
from the floppy with the root on the hard disk.

i suspect the problem is that the xenix bootstrap
program on the hard disk makes some assumptions
about the characteristics of the hard disk which
are not correct.  probably the bootstrap program
on the floppy obtains these parameters from
somewhere rather than making asumptions about it.

i will welcome any suggestions about how to solve
this problem.  i can adjust the pulse step rate
and the interleave factor.

thanx very much.

nasser

Technical Details

Message-ID: <14877@ucbvax.BERKELEY.EDU>

Path: arc1-ca.pugleaf.net!utzoo!utcs!mnetor!seismo!caip!nike!ucbcad!ucbvax!nasser

Show Full Headers

Complete Article Headers

Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: arc1-ca.pugleaf.net!utzoo!utcs!mnetor!seismo!caip!nike!ucbcad!ucbvax!nasser
From: nasser@ucbvax.UUCP
Newsgroups: net.micro.pc
Subject: xenix with the adaptek rll controller
Message-ID: <14877@ucbvax.BERKELEY.EDU>
Date: Wed, 16-Jul-86 03:06:34 EDT
Article-I.D.: ucbvax.14877
Posted: Wed Jul 16 03:06:34 1986
Date-Received: Wed, 16-Jul-86 08:43:18 EDT
Organization: University of California at Berkeley
Lines: 23
Keywords: xenix, boot, rll hard disk controller