🚀 go-pugleaf

> In article <739@oakhill.UUCP>, luis@oakhill.UUCP (Luis Basto) writes:
> > I started using NANSI.SYS recently and was very satisfied with its faster
> > screen scrolling. ...
> > However, there seems to be a problem when using it with Turbo Prolog.
> > Everything works normally except on Quit. Then the screen blanks completely
> 
>                                Ever think of typing "mode co80" even
> though the screen is comatose and you get no response to the
> keystrokes?  It worked for me.  Seems Turbo_Prolog QUITs leaving the
> system in "Monochrome Monitor" mode or at least not a "Color Monitor"
> mode.  (I have not gotten around to contacting Borland about this.)

I use a monochrome monitor, and the same thing happens.  I thought it must be
issuing an ANSI sequence to set the colors to black-on-black or something.
But the CLS command restores the screen, too.  If it were the ANSI sequence
for black-on-black, the screen should just clear to all black-on-black.  So,
Borland must be issuing an int 10h directly?  If that were it, a change in
the driver would seem to make no difference.  I give up.

> --      andyiii
-- 
bc				Bill Crews @ NetCor Data International

..!{seismo,gatech,ihnp4}!ut-sally!cyb-eng!bc  (512) 835-2937