🚀 go-pugleaf

In article <1380@ulysses.UUCP> jld@ulysses.UUCP (Jeff David) writes:
>I have a Leading Edge Model D (IBM Compatible) and an old Apple II+ sitting
>next to each other.  Each has a modem attached.  I would like to hook these
>two together so that (at a minimum) I could move ASCII files between the
>two.  It would also be nice if I could get one to act like a terminal off
>the other (as host).  How do I go about doing this?  Do I have to use the
>modems or can I use the serial interfaces?  I don't want to have to write
>any assembler code.  Has anybody tried to do this?  Is there an easy solution?
>Thanks in advance for any help.
>

 Run kermit on both machines and tie the two modums together. Most serial 
cards can be used with direct connection. On an apple super serial card
turn the jumper block to terminal and the connection will work as if you
had a phone line going. I have connected a kaypro and franklin(apple ii+)
together and ran them at 19200 baud. Boy does the data fly.