🚀 go-pugleaf

>Problem #1
>I can not do any file transfers with a
>BSD 4.2 unix system.  I have tried many different Procomm configurations
>but none seem to work.  Does anyone know the magic combination?

depends on which kermit you are running on the BSD side.  i use C-Kermit
4C(057) with procomm2.3 all the time with no problems.  there ARE a couple
gotchas, tho.  i have to run procomm with even parity (xxxx-E-7-1) to do
terminal emulation without greek.  (i tried using the translate table to
convert all the >=0x80 characters to ascii; this made the screen readable,
but the terminal emulation wouldn't work -- ie, escape sequences were
mis-interpretted).  remember to change this to no parity (xxxx-N-8-1)
before a transfer.

>Problem #2
>     Procomm's Alt-H does hang up my Qubie internal modem but it does
>not detect that the hangup was successful.  I have tried all the CD 
>masks 1-128 that are allowed and it still doesn't work.  Any suggestions?

i had the same problem until i changed the switches on my hayes 1200b
to make it raise and lower DCD properly.  if procomm sees DCD high after
an ALT-H, it will assume the hang-up failed.

	wayne hamilton
	U of Il and US Army Corps of Engineers CERL
UUCP:	{ihnp4,pur-ee,convex}!uiucdcs!uiucuxc!hamilton
ARPA:	hamilton%uiucuxc@a.cs.uiuc.edu	USMail:	Box 476, Urbana, IL 61801
CSNET:	hamilton%uiucuxc@uiuc.csnet	Phone:	(217)333-8703
CIS:    [73047,544]			PLink: w hamilton