🚀 go-pugleaf

> In article <3312@utcsri.UUCP> henderso@utcsri.UUCP (Mark Henderson) writes:
> >I heard recently that the 80287 runs at a clock speed of only 5.3 MHz when
> >in an IBM AT and also that one can purchase a small board which fits into the
> >80287 socket on the AT, to drive it at 8 MHz (assuming of course one has an
> >80287-8). Where can one purchase such a board? Any information would be
> >appreciated. If you have them, please include prices.
> 
> Depending on what you are using, putting a 287 may not get you
> anywhere.  In fact, it may slow down your system!  
>  
> You may want to check the IBM special issue (10/85) of Byte, page 66 on.
> the benchmarks that they ran did not give the increase in proformence
> that you might expect.  In at least one case it slowed it down.
> 
> They used different clocks for both the 286 and 287;
> 286: 6 & 9 MHz
> 287: 0, 4, & 8 MHz
>  
> You might check byte for the speed up board for the 287, as I have seen
> them in byte.
> 
> greg waldref
> 
> ....tektronix!psu-cs!psueea!waldref

As I understand it, the faster your 286 goes the faster your 287 should go. 
Best bet would be to match the speed of your 286 with a 287 of comparable or
faster speed. Microway, Inc. in the Boston-area makes MANY 287-type speed up
products.


-- 

-- Ed.
    
Net  :  {noao!ihnp4!yale!}!hsi!tankus
Snail:  Health Systems Int'l, 100 Broadway, New Haven, CT 06511
Bell :  (203) 562-2101