🚀 go-pugleaf

lairdt@storm.CS.ORST.EDU (Tom Laird) writes:

>I have been running a CDC-702 SCSI driveo n a 6130 for several months now.
>I recently have run into problems with erros messages showing up all of the
>time on my screen. The error message I get is "<Utek> sense key=1 extended
>sense=15" "disk block number 274836". I reformatted the drive, fsck goes
>through with no problems. When I went to run scsifmt it came on at first
>and said "MPAT corrupted" three times. I got no errors formatting the drive.

>Does anyone have any help for me on this problem?

Well, it appears that the drive is trying to seek to an invalid
position on the drive.  Here's a (brief) list of SCSI errors that
I haved around here...

Sense key:

        0H:        No sense        (No error)
        1H:        Recovered error (retried sucessfully)
        2H:        Not ready       (device can not be accessed)
        3H:        Medium error    (Media error)
        4H:        Hardware error  (controller error)
        5H:        Illegal request (Invalid CDB parameter)
        6H:        Unit attention  (unit has been reset)
        7H:        Data Protect    (read/write protected device)
        BH:        Aborted command (Command aborted)
        EH:        Miscompare      (Checksum error)

Extended sense:
        00H:       None additional info available
        01H:       No Index/sector signal
        02H:       No seek complete
        03H:       Write fault
        04H:       Drive not ready
        05H:       Drive not selected
        06H:       No track zero found
        07H-0FH:   Reserved
        10H:       ID CRC error
        11H:       Unrecovered read
        12H:       No address mark found in id field
        13H:       No address mark found in data field
        14H:       No record found
        15H:       Seek positioning error
        16H:       Reserved
        17H:       Recovered read (with retries)
        18H:       Recovered read (with ECC)
        19H:       Defect list error
        1AH:       Parameter overrun
        1BH:       Reserved
        1CH:       Primary defect list not found
        1DH-1FH:   Reserved
        20H:       Invalid command code
        21H:       Invalid logical block address
        22H-23H:   Reserved
        24H:       Illegal field in CDB
        25H:       Invalid LUN
        26H:       Invalid field parameter list
        27H:       Write protected
        28H:       Reserved
        29H:       Poweron reset or bus device reset
        2AH:       Mode select parameters changed
        2BH-30H:   Reserved
        31H:       Format failed
        32H:       No defect spare location available
        33H-3FH:   Reserved
        40H:       Ram failure
        41H:       Data path diag failure
        42H:       Power on diag failure
        43H:       Message reject
        44H:       SCSI hardware/firmware error
        45H:       Select/reselect failed
        46H:       Reserved
        47H:       SCSI parity error
        48H:       Initiator detected error
        49H:       Inappropriate/Illegal message
        4AH-69H:   Reserved
        6AH:       Format required
        6BH-6F:    Reserved
        70H-7FH:   Selftest '7x' failed
        80H-8BH:   Correctable ECC error. (# bits == {0=b})
        8CH-8FH:   Reserved
        90H:       Configuration error
        91H-FFH:   Reserved

    -Jeff
-- 
Jeff Beadles		jeff@onion.rain.com