🚀 go-pugleaf

Hi,

I'm using a Global Village Teleport Gold with interSLIP on a Mac Quadra
610. I recently upgraded to 2.5.5 of their software, and have been having
some minor problems since then.

With v 2.08b, if the v.42bis setting was checked in the Teleport Control
Panel, and the Init Modem checkbox was checked, the modem would connect to
the Pitt Modem pool and show a check next to v.42bis in the staus menu.
This, I assumed, meant the modem was connected and v.42bis compression was
activated.

Since I upgraded to 2.5.5, this is no longer the case. Even though the
Control Panel stting is the same, the staus menu no longer shows v.42bis
as active, and transfer times are quite a bit slower.

InterSLIP uses a dialing script (in this case a modified ARA 1.0 dialing
script) to negotiate the connection with our modem pool. in this script
there are settings written to the modem. Here is the relevant pieces of
the script:

___________start of script segment___________________________________
! First recall the factory configuration
!
settries 0
matchclr
@LABEL 1
matchstr 1 3 "OK\13\10"
write "AT&F&C1\13"
matchread 30
inctries
iftries 2 59
jump 1
!
! &f   - recall factory settings
! \q2  - Use Unidirectional RTS/CTS flow control
! \k0  - Enter command state but do not send break
! \j0  - Disable port rate adjust
! S0=0 - Don't answer calls
! E0   - Turn command echo off
! \n0  - disable all error correction and compression 
! %c0  - turn off MNP5 compression
!
@LABEL 3
Flush
pause 10
HSReset 0 1 0 0 0 0
settries 0
matchclr
@LABEL 5
matchstr 1 6 "OK\13\10"
! &F  - recall factory settings
! &D3 - Reset Modem on On-to-Off DTR transitions
! \J0 - Disable auto port rate adjust
! W2  - Connect result code reports modem speed
! \Q2 - Unidirectional flow control
! S7=60 - To allow for an international call
! S0=0 - Don't answer calls
! E0   - Turn command echo off
! \N0 - Enter normal mode (no reliability protocols)

write "AT&F&D3\\J0W2\\Q2S7=60S0=0E0\\N0\13"

matchread 50
inctries
iftries 2 59
jump 5
!

___________end of script segment___________________________________


What I would like to do is modify this script so that v.42bis compression
is enabled.

Can anyone help? Please post responses to me as e-mail at
cmcst42@pitt.edu. Thanks.

Chris

-- 
Chris Connors                                    
cmcst42+@pitt.edu
connors.c@applelink.apple.com
http://www.pitt.edu/~cmcst42/cmc.html