🚀 go-pugleaf

In article <5716@dasys1.UUCP> mikej@dasys1.UUCP (Mike Johnston) writes:
|In article <273@mjbtn.UUCP> root@mjbtn.UUCP (Mark J. Bailey) writes:
|>I am having an annoying problem that some of you may have also experienced.
|>my modems set to answer at 2400 baud and then cycle to 1200 on a CR and then
|>back to 2400.  They are supposed to reset to 2400 baud at logoff, aren't 
|>they?
|
|I have had similar problems. A partial victory might be achieved by setting
|your modems to reset on a dtr change. I.E. ATD0 I believe. Thus, when the
|getty drops the line (dtr low) the modem performs an ATZ on itself and
|resets back to 2400 baud.

this has the nasty side effect for non-hayes modems of possibly resetting
the D0 flag after the reset, which causes the next hangup to NOT reset the
modem.  for hayes modems you must remember to store the command into
non-volatile memory so that the reset will not turn off that option.

- john.
-- 
John F. Haugh II                 +--------- Cute Chocolate Quote ---------
HASA, "S" Division               | "USENET should not be confused with
UUCP:   killer!rpp386!jfh        |  something that matters, like CHOCOLATE"
DOMAIN: jfh@rpp386.uucp          |             -- with my apologizes