Twist in the Wing

Article View: rec.models.rc

Article #1964

#1964

From: Chris `Choke' Johnson
Date: Sun, 24 Jan 1993 20:40

19 lines
1374 bytes

I am looking for the summary of the discussion regarding what to do with
a warped wing.  I am returning to modeling with a Sig Kadet MKII.  I
unfortunately seemed to build a twist into the wing though.  currently,
if the wing is flat on the table, the outside rear corner is raised by
about .25 inches.  I have not done any covering yet.  The wing is just
about ready for final sanding, and then connecting the halves.  All
sheating and capstrips are glued in.  

                     thanks for the help.

e-mail to JohnsonC@spot.Colorado.EDU 

                      Chris Johnson

-- 
^----------^----------^----------^----------^----------^----------^----------^
|   JohnsonC@Spot.Colorado.EDU     :    ->CHoKE<- It's a band,               | 
|   O. Phone (303) 492-5031        :          It's a lifestyle               |
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>

Technical Details

Message-ID: <johnsonc.727908007@spot.Colorado.EDU>

Path: arc1-ca.pugleaf.net!sparky!uunet!boulder!ucsu!spot.Colorado.EDU!johnsonc

Show Full Headers

Complete Article Headers

Newsgroups: rec.models.rc
Path: arc1-ca.pugleaf.net!sparky!uunet!boulder!ucsu!spot.Colorado.EDU!johnsonc
From: johnsonc@spot.Colorado.EDU (Chris `Choke' Johnson)
Subject: Twist in the Wing
Message-ID: <johnsonc.727908007@spot.Colorado.EDU>
Summary: Straightening a warped wing
Sender: news@ucsu.Colorado.EDU (USENET News System)
Nntp-Posting-Host: spot.colorado.edu
Organization: University of Colorado, Boulder
Date: Sun, 24 Jan 1993 20:40:07 GMT
Lines: 19