🚀 go-pugleaf

I seem to remember reading a technique article in FineScale Modeler some
years back. The guy was using the wrappers from Nestle's Crunch bars 
(not those NBA commemorative bars though - they have a paper backing
on the foil. Use the silver kind). For an adhesive he used the 3M spray
adhesive thinned with lacquer thinner. (At least I THINK that was the 
adhesive). Personally I use BareMetal Foil, which comes with an 
adhesive backing. Only two problems with BareMetal foil - 1) it's a bit
expensive and hard to find. 2) The adhesive has a limited shelf life. 
I recently had to discard an entire sheet of BareMetal that was only
1 year old. Stuff wouldn't stick at all. Bummed me right out.

					Richard

-- 
*-----------------------------------------------------------------------*
* "Listen, three eyes," he said, "don't you try to outweird me, I get   *
*  stranger things than you free with my breakfast cereal."             *
*-----------------------------------------------------------------------*
* Richard L. Wright, Jr             * Disclaimer:                       *
* Data General Corporation          *  The views expressed here are the *
* System Evaluation and Performance *  One True Way to Enlightenment.   *
*   Analysis Center (SEPAC)         *  Everyone shares my views, they   *
* Norcross, Georgia, USA  30092     *  just don't realize it yet.       *
* (404) 448-6072                    *      Riiiiiight.                  *
*-----------------------------------------------------------------------*