🚀 go-pugleaf

In article <8661.27cc7da1@jetson.uh.edu> mece1v0@jetson.uh.edu writes:
-
-I am searching for a microprocessor that was
-discussed in one of the electronics magazine. The
-one I am interested in had a built in Basic
-interpreter that allowed the EPROM to be programed
-in straight basic.

You are looking for the 8052AH-BASIC (a member of the 8051/52 family with
BASIC in rom.  I believe Jameco sells it (but watch out for their new $50
minimum.)  Your best bet is to call Micro Mint (Steve Ciarcia's group).
They sell the chip, and a whole slew of single-board systems based on it.
Their phone number is 800 635-3355.

-I am going to use two of the Sharp
-infrared modules sold by Radio Shack as the
-transducers.
Just remeber that the LED will have to be running at 40 KHz for the detector
to pick it up.  Steve had an article on a laser beam-break detector in
an issue of Circuit Cellar Ink a few issues back.  Micromint should also 
sell back-issues of CCI.

-  My goals are to have four readouts
-available which are feet per second, meters per
-second, miles per hour, and kilometers per hour. 
You may want to use one of those LCD 2 linex20 char displays for this.
Info on talking to them is in back-issues of CCI, R-E, PopTronics, or
Modern. (I am sure of CCI and R-E.  At least one of the other two also had it)

Send me mail if you can't find those back issues.

Good Luck.
/mike
-- 
\|/  Michael L. Ardai   Teradyne EDA East
--- -------------------------------------------------------------------------
/|\  ...!sun!teda!ardai (preferred)  or ardai@bu-pub.bu.edu