Article View: sci.electronics
Article #11809Re: Need small tool to cut pcb board
From: Kip J. Mussatt
Date: Tue, 06 Oct 1992 12:04
Date: Tue, 06 Oct 1992 12:04
14 lines
968 bytes
968 bytes
In <Bvnv3y.89B@acsu.buffalo.edu> v064mb9k@ubvmsb.cc.buffalo.edu (HELLO) writes: > I am working on a device that I want to manufacture in short numbers. >The pc board dimensions are roughly 3*3 inches. Its much easier >to cut my own from stock. Is there a cheap or inexpensive tools that >could cut 1/16th inch double sided clad board neatly? I have had good luck with a good hacksaw and a vice. Coping saws are ok, but the finer blades on hacks saws seem to work better. -Kip J. Mussatt -- hampster@phys.ksu.edu
Technical Details
Message-ID:
<1arvbpINN9cn@moe.ksu.ksu.edu>Path:
arc1-ca.pugleaf.net!sparky!uunet!spool.mu.edu!uwm.edu!zaphod.mps.ohio-state.edu!moe.ksu.ksu.edu!phys.ksu.edu!hampsterReferences:
<Bvnv3y.89B@acsu.buffalo.edu>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!sparky!uunet!spool.mu.edu!uwm.edu!zaphod.mps.ohio-state.edu!moe.ksu.ksu.edu!phys.ksu.edu!hampster From: hampster@phys.ksu.edu (Kip J. Mussatt) Newsgroups: sci.electronics Subject: Re: Need small tool to cut pcb board Date: 6 Oct 1992 12:04:09 GMT Organization: Kansas State University Lines: 14 Message-ID: <1arvbpINN9cn@moe.ksu.ksu.edu> References: <Bvnv3y.89B@acsu.buffalo.edu> NNTP-Posting-Host: bohr.phys.ksu.edu