Article View: sci.electronics
Article #11887Re: Need small tool to cut pcb board
From: Gerald Vernon Nelson
Date: Wed, 07 Oct 1992 02:22
Date: Wed, 07 Oct 1992 02:22
14 lines
1129 bytes
1129 bytes
>> I am working on a device that I want to manufacture in short numbers. >>The pc board dimensions are roughly 3*3 inches. Its much easier >>to cut my own from stock. Is there a cheap or inexpensive tools that >>could cut 1/16th inch double sided clad board neatly? I really don't see why you couldn't run it through a table saw or radial arm saw. Use a fine tooth blade for soft metals. I use a radial arm saw to cut aluminum sheets, and it works pretty good. Make sure you got a really good grip on the sheet. Vice grips would help. Vern Nelson
Technical Details
Message-ID:
<1992Oct7.022232.13781@ccu.umanitoba.ca>Path:
arc1-ca.pugleaf.net!sparky!uunet!wupost!zaphod.mps.ohio-state.edu!cis.ohio-state.edu!rutgers!utcsri!newsflash.concordia.ca!ccu.umanitoba.ca!vnelsonReferences:
<Bvnv3y.89B@acsu.buffalo.edu> <1arvbpINN9cn@moe.ksu.ksu.edu>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!sparky!uunet!wupost!zaphod.mps.ohio-state.edu!cis.ohio-state.edu!rutgers!utcsri!newsflash.concordia.ca!ccu.umanitoba.ca!vnelson From: vnelson@ccu.umanitoba.ca (Gerald Vernon Nelson) Newsgroups: sci.electronics Subject: Re: Need small tool to cut pcb board Message-ID: <1992Oct7.022232.13781@ccu.umanitoba.ca> Date: 7 Oct 92 02:22:32 GMT References: <Bvnv3y.89B@acsu.buffalo.edu> <1arvbpINN9cn@moe.ksu.ksu.edu> Sender: news@ccu.umanitoba.ca Organization: University of Manitoba, Winnipeg, Canada Lines: 14 Nntp-Posting-Host: ccu.umanitoba.ca