HELP with Qume Terminal

Article View: sci.electronics

Article #14281

#14281

From: Punster at Large
Date: Mon, 17 Jun 1991 00:05

15 lines
1259 bytes

shape with one except;ion.  The terminal doesn't respone to its setup key. 
Since it is in such good condition, is it possible that one of the previous
owners chose a model that didn't allow the setup to be changed.  I could see
certain conditions where this may be preffered.  Does anybody have any ideas
on reactivating the setup key.  Note I did open the terminal up and there are
no dip switches or any apparent selection connections.

There was a battery, I removed it so that any internal parameters would be
cleared and then replaced it with no avail.  It is possible I didn't give the
circuit enough time to discharge. 

Thanks

  Jim
  RUSH@ENVMSA.EAS.ASU.EDU

Technical Details

Message-ID: <16JUN91190558@envmsa.eas.asu.edu>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!cs.utexas.edu!rice!uw-beaver!milton!envmsa.eas.asu.edu!rush

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!cs.utexas.edu!rice!uw-beaver!milton!envmsa.eas.asu.edu!rush
From: rush@envmsa.eas.asu.edu (Punster at Large)
Newsgroups: sci.electronics
Subject: HELP with Qume Terminal
Message-ID: <16JUN91190558@envmsa.eas.asu.edu>
Date: 17 Jun 91 00:05:58 GMT
Sender: news@milton.u.washington.edu (News)
Reply-To: rush@envmsa.eas.asu.edu
Organization: College of Engineering, Arizona State Univ
Lines: 15
News-Software: VAX/VMS VNEWS 1.4-a3  
   I recently purchased a used Qume terminal.  It works fine and is in great