🚀 go-pugleaf

Any crystal rated between 20 and 60 MHz is going to be a "third overtone"
type which is capable of oscillating at both F and 3F, where 3F is the
frequency marked on it.  For example, a 27-MHz CB crystal will also
oscillate (in fact will more easily oscillate) at 9 MHz.

Very simply, your 24-MHz crystal chose to oscillate at its 8-MHz
fundamental rather than its 24-MHz overtone.  (You could also get it
to oscillate at 5F, which is 40 MHz, in a suitable circuit.)

Overtone crystal oscillators almost always contain a tuned circuit
to prevent oscillation at the lower frequency. Your circuit doesn't
look like an overtone oscillator; it has nothing to prevent oscillation
at the lower frequency. You might *try* replacing the .01 uF capacitor
with something a lot smaller, but don't count on it.

The easiest thing to do, if you're clocking a microprocessor, is to
use a hybrid IC oscillator -- that is, a whole oscillator in a can
the size of an IC. These have all the frequency-determining components
built in; just apply 5 volts and you get a nice 5-volt square wave out.





-- 
-------------------------------------------------------
Michael A. Covington | Artificial Intelligence Programs
The University of Georgia  |  Athens, GA 30602   U.S.A.
-------------------------------------------------------