🚀 go-pugleaf

In article <10919@fluke.COM> inc@tc.fluke.COM (Gary Benson) writes:
>    A. What the "bias" voltage is for a typical small flashtube, and is it
>       DC or AC? If AC, what frequency?

Flashtubes need a DC supply of ~100V-500V. When you connect a spike of a few
thousands of volts to the trigger connection (eg. from the spark plug) your
flashtube triggers. You should have your hi-volts energy stored in a capasitor
of 10uF...470uF. After your strobe has been triggered your capasitor (connected
on the stobe) discharges through the flashtube.

>    B. Where I can get a "ballpark" schematic to start playing with,
>       modifying, etc?

There were some shematics in Modern Electronics, July and August 1988.

The most typical circuit is made the following way:

You connect a oscillator to a 6.3V-120V transformer in 'reverse'. At the high
voltage section you rectify hi-volts with a couple of diodes, store energy in
a capasitor and connect the capasitor to the strobe. One end of the capasitor
should be also connected to lo-volts ground connection. You connect the trigger
connection to your spark plug.  You can power a step-up circuit like this
from your car battery.
---  
E-mail:  c37189h@saha.hut.fi             *   If you're feeling good, don't  *
UUCP:    ...!mcvax!santra!saha!c37189h   *   worry  -  You'll get over it!  *