Surface mount device prototyping

Article View: sci.electronics

Article #14779

#14779

From: Simon Cocking
Date: Thu, 19 Nov 1992 07:28

13 lines
1198 bytes

I just got some specs for the MC68HC16Z1, and it looks like there is only a
PQFP / PQFP in a molded carrier ring package available.  My question is,
how would one go about prototyping (read wirewrapping) with one of these?
Are there sockets available which take these devices?  Or am I going to have
to construct a small daughter board to mount it on?

Thanks,
Simon.
-- 
+---------------  Simon Cocking, sgc@yoyo.cc.monash.edu.au  -------- /// -+
|               Robotics & Digital Technology / GAUnix Group        ///   |
|                             Monash University                 \\\///    |
+-------------------------  Melbourne, Australia.  ------------- \XX/ ----+

Technical Details

Message-ID: <rda735z.722158097@nella16.cc.monash.edu.au>

Path:

arc1-ca.pugleaf.net!sparky!uunet!cs.utexas.edu!qt.cs.utexas.edu!yale.edu!think.com!ames!network.ucsd.edu!munnari.oz.au!bruce.cs.monash.edu.au!monu6!nella16.cc.monash.edu.au!rda735z

Show Full Headers

Complete Article Headers

Newsgroups: sci.electronics
Path: arc1-ca.pugleaf.net!sparky!uunet!cs.utexas.edu!qt.cs.utexas.edu!yale.edu!think.com!ames!network.ucsd.edu!munnari.oz.au!bruce.cs.monash.edu.au!monu6!nella16.cc.monash.edu.au!rda735z
From: rda735z@nella16.cc.monash.edu.au (Simon Cocking)
Subject: Surface mount device prototyping
Message-ID: <rda735z.722158097@nella16.cc.monash.edu.au>
Sender: news@monu6.cc.monash.edu.au (Usenet system)
Organization: Monash University, Melb., Australia.
Date: Thu, 19 Nov 1992 07:28:17 GMT
Lines: 13