🚀 go-pugleaf

washer@sequent.com (Jim Washer) writes:

>I've been playing with PADS logic and pcb, and have managed to 'capture'
>my schematic, create the netlist, and read it in using pcbshare.

>I have not managed to route it (auto route I hope), nor print a postscript
>image of the etch (single sided board).

   Did you place the parts?   You can use auto-place, but that is
more complicated.   When you read in the net list all parts are
piled on top of each other at the origin (0,0).   This is at
the lower left of the screen by default.   It can be off the
screen if you have scrolled the drawing area.   To see them
easily zoom in on the origin to blow the parts and use the move
command to pull them where you want.   Then you can use auto-route.

Hope that this helps.

--
>>>>>>>>>>>> Peter Reilley ..... pvr@wiis.wang.com ..... KA1LAT <<<<<<<<<<<<<
                     Well, that about says it.