🚀 go-pugleaf

hb@imsor.dth.dk (Henrik Bechmann) writes:
> I have one of those fitted in my car, and the users manual states that
> it is possible to switch between voltage sensing mode and no voltage
> sensing mode by setting a switch. I don't want it to be voltage
> sensing, but the alarm reacts on voltage changes in both modes :-( 
> 
> Does anybody out there have any suggestions to solve the problem
> (without a separate battery for the alarm), or does anybody have acces
> to a Service Manual or an electronics diagram of the thing?
> 
> Any help will be very much apreciated.
> 
> Henrik.
> --
> -----------------------
> ! Henrik Bechmann     !
> ! hb@vip.imsor.dth.dk !
> -----------------------

Not being familiar with this particular alarm, I cannot say how to
turn off current sensing... contact the manufacterer or a
retailer/installer for that.  But, if nothing else, you will probably
find that if you relocate the current sensing wire to the + terminal
of the battery instead of the fuse box (common spot), the current
sensing will be desensitized quite a bit... though this varys greatly
from vehicle to vehicle.

				- Jason
-- 
---------------------------------------------------------------
\ Jason A. Reiser  \ Send E-Mail to jreiser@scott.skidmore.edu \
 \ Skidmore College \ Saratoga Springs, NY 12866 \ 518-581-6580 \  
  \ It's a new Ice Age!  Hooray!!  Sled City!  - Calvin & Hobbes \