🚀 go-pugleaf

In article <85397@ut-emx.uucp> bg@ccwf.cc.utexas.edu (Brent Goodrick) writes:
>I have the shareware student version of MicroSim's Schematic Simulator
>(the one that runs under Windows), but I do not have access to any
>reference manuals.  Here's my question:  How do I tell the program
>to display the names of the nodes that are passed to PSpice via the
>netlist file?  For example:  I have setup a simple circuit with a 3V
>independent voltage source in series with a 1ohm resistor and a 2ohm
>resistor.  This is the netlist generated by the Schematic Simulator:
>
>* Schematics Netlist *
>
>v_V1     $N_0002 0 dc 3v  
>R_r1     $N_0002 $N_0004 1ohm 
>R_r2     $N_0004 0 2ohm
>
>If possible, I want the program to display the nodes "$N_0002" and
>"$N_0004" in the appropriate places on screen, kinda like this:
>
>
>                          node $N_0002
>             +--------------------------------+
>             |                                |
>             |+                               |
>      V1voltagesource                     1ohmresistor
>             |-                               |
>             |                                | node $N_0004
>             |                                |
>             |                            2ohmresistor
>             |                                |
>             |                                |
>             +---------------+----------------+
>                             |
>                            grnd
>
>Otherwise, I spend a lot of time trying to figure out what the program
>has assigned as the plus node of a resistor, which really is misnomer
>anyway.
>
>Thanks in advance
>Brent Goodrick - Electrical Engineering - University of Texas
>bg@ccwf.cc.utexas.edu
>


The easiest way to do this is to use the markers, click on the markers pull-down
select a marker, then just mark the nodes you want to measure.  At least I
think it should work that way.  I just downloaded a copy and started playing
with it a few days ago.

BTW - The copy I downloaded seems to missing some of the libraries, e.g.
    burr_brn.slb
    dig_ecl.slb
    opto.slb
    misc.slb
    special.slb
    swit_rav.slb
    swit_reg.slb
    thyristr.slb
    xtal.slb
    dig_pal.slb
    dig_gal.slb
    europe.slb
    markers.slb

Do you know where I can get this?  Also, is there an ftp site around with
models, libs, circuits, and such that can be downloaded?

Thanks,

-- 
Mont Pierce

+-------------------------------------------------------------------------+
| Ham Call: KM6WT             Internet:  mont@netcom.com                  |
|    bands: 80/40/20/2        IBM vnet:  mont@vnet.ibm.com                |
|    modes: cw,ssb,fm                                                     |
|      qth: Fremont, CA       Religion:  Jehovah's Witnesses    9/72      |
+-------------------------------------------------------------------------+