Printer question in PADS... :-(

Article View: sci.electronics

Article #16151

#16151

From: slmdj
Date: Thu, 21 Jan 1993 15:57

17 lines
1406 bytes

Another question, while I'm on a roll :-)
In PADS (logic or PCB), when I start up I get the message flashed on the top of
the screen "Printer output redirected to ..../logfil.err"  Then, when I try to
print a schematic I have drawn up, I get no response from the printer. :-(  I
have run the setup program and selected the correct printer (NEC P5200, I
believe) but it still doesn't do what I need!   Any suggestions would be
_greatly_ appreciated...

Thanks,
-- 
********************************************************************************
      Paul Cowley      * ..."It's easier said than done."   And if you don't 
   ==EE Undergrad==    * believe it, try proving that it's easier done than
 Utah State University * said and you'll find that 'it's easier said that "it's
  C/A1C  CAP Utah Wing * easier done than said" than it is done.'  Which really
   slmdj@cc.usu.edu    * proves that it's easier said than done.
********************************************************************************

Technical Details

Message-ID: <1993Jan21.095753.62980@cc.usu.edu>

Path:

arc1-ca.pugleaf.net!sparky!uunet!olivea!spool.mu.edu!uwm.edu!zaphod.mps.ohio-state.edu!saimiri.primate.wisc.edu!ames!agate!dog.ee.lbl.gov!hellgate.utah.edu!cc.usu.edu!slmdj

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!sparky!uunet!olivea!spool.mu.edu!uwm.edu!zaphod.mps.ohio-state.edu!saimiri.primate.wisc.edu!ames!agate!dog.ee.lbl.gov!hellgate.utah.edu!cc.usu.edu!slmdj
From: slmdj@cc.usu.edu
Newsgroups: sci.electronics
Subject: Printer question in PADS... :-(
Message-ID: <1993Jan21.095753.62980@cc.usu.edu>
Date: 21 Jan 93 15:57:53 GMT
Organization: Utah State University
Lines: 17