PC board etching question

Article View: sci.electronics

Article #16234

#16234

From: Richard Plourde
Date: Mon, 04 Jan 1993 23:06

25 lines
962 bytes

Reply to Rich Gopstein regarding PC board etching question

RG>From: gopstein@helix.bms.com (Rich Gopstein)
RG>Organization: Bristol-Myers Squibb PRI
RG>

RG>1) Can I realistically make double sided PC boards?  My first board
wi
RG>   single-sided, but I would like to try more complicated boards
later
RG>

Remember, you do not have plated-through holes.  All components will
have
to be soldered on both sides, while vias will need to be connected
through
with a scrap piece of wire.  It's all a nuisance, but it does work.

Richard Plourde - Nashua NH
rplourde@leotech.mv.com



 * Origin: Leo Technology (603)432-2517/432-0922 (HST/V32)
(1:132/189)

Technical Details

Message-ID: <726223713.F00001@leotech.mv.com>

Path: arc1-ca.pugleaf.net!sparky!uunet!noc.near.net!mv!leotech!uucp

Show Full Headers

Complete Article Headers

From: rplourde@leotech.mv.com (Richard Plourde)
Sender: uucp@leotech.mv.com
Path: arc1-ca.pugleaf.net!sparky!uunet!noc.near.net!mv!leotech!uucp
Newsgroups: sci.electronics
Subject: PC board etching question
Message-ID: <726223713.F00001@leotech.mv.com>
Date: Mon, 04 Jan 1993 23:06:00
Lines: 25