Article View: sci.electronics
Article #16268Re: PC board etching question
From: Darin Latimer
Date: Tue, 05 Jan 1993 16:27
Date: Tue, 05 Jan 1993 16:27
14 lines
1190 bytes
1190 bytes
In article <726223713.F00001@leotech.mv.com>, rplourde@leotech.mv.com (Richard Plourde) writes: |> Remember, you do not have plated-through holes. All components will |> have |> to be soldered on both sides, while vias will need to be connected |> through |> with a scrap piece of wire. It's all a nuisance, but it does work. |> |> Richard Plourde - Nashua NH |> rplourde@leotech.mv.com Is it possible to do your own through hole plating? I have seen the press in rivet type vias but was warned away from them as they tend to form flaky connections. How is the through hole processing completed at a board house? Thanks for any info, Darin.
Technical Details
Message-ID:
<1993Jan5.162702.18205@organpipe.uug.arizona.edu>Path:
arc1-ca.pugleaf.net!sparky!uunet!cis.ohio-state.edu!zaphod.mps.ohio-state.edu!cs.utexas.edu!asuvax!ncar!noao!amethyst!organpipe.uug.arizona.edu!iris4.chem.arizona.edu!dlatimerReferences:
<726223713.F00001@leotech.mv.com>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!sparky!uunet!cis.ohio-state.edu!zaphod.mps.ohio-state.edu!cs.utexas.edu!asuvax!ncar!noao!amethyst!organpipe.uug.arizona.edu!iris4.chem.arizona.edu!dlatimer From: dlatimer@iris4.chem.arizona.edu (Darin Latimer) Newsgroups: sci.electronics Subject: Re: PC board etching question Message-ID: <1993Jan5.162702.18205@organpipe.uug.arizona.edu> Date: 5 Jan 93 16:27:02 GMT References: <726223713.F00001@leotech.mv.com> Sender: news@organpipe.uug.arizona.edu Organization: Chemistry Dept. Univ. of Arizona Lines: 14