🚀 go-pugleaf

I have been trying to use PADS PCB to create a small card which has an
card-edge connector, and I'm having a devil of a time trying to get it
to do what I want.

I want to create a part which has pads on both sides of a two layer
board, but which are not connected. I've created a decal with 64 pins,
and messed with the pad stacks so that pins 1-32 on the bottom layer
and 33-64 are on the top. Then I create a part with the decal.  When I place
the part, it only seems to put it on one layer, and I can't get at the
pins which are on the other one.

Where am I going wrong here? Any gurus care to offer some help?

Oh. Instead of creating a "part" using the decal, I've tried creating a
"connector", but with worse results. There, it complains about an
invalid pin or something like that. Help!

Rick
-- 

Rick McTeague
Electrical Engineering Department, Speed Scientific School
University of Louisville, Louisville, KY 40292
(502) 588-7020

Internet: sysrick@starbase.spd.louisville.edu

Disclaimer: I'm a stand-up comedian; if anyone takes me seriously, I'm
            doing something wrong!