EPROM programming info.

Article View: sci.electronics

Article #16703

#16703

From: Tom. Adams 529-7860
Date: Fri, 08 Jan 1993 14:45

15 lines
1137 bytes

A while back I bought a very old EPROM programmer, which requires 
jumper changes for various types of EPROMS, and using a resistor as
a jumper to change programming voltages.  It also is extremely dumb
wrt programming and reading.  You send it a character and it writes
it and increments the address.

I'm looking for pointers to programming information for various EPROMS,
and the file formats used by common programmers.

Are all, say, 2764's programmed the same or do different manufacturers
use different times and voltages?  Where can I find out more about this?
-- 
Tom Adams	tadams@sbctri.sbc.com 	Voice 314-529-7860, FAX 314-529-7573
If we bounce your mail, and you can fax me the errors, it would be greatly
appreciated.  I need it to get someone to address the email problems here.

Technical Details

Message-ID: <1993Jan8.144544.4162@sbctri.sbc.com>

Path: arc1-ca.pugleaf.net!sparky!uunet!wupost!calvin.sbc.com!tadams

Show Full Headers

Complete Article Headers

Newsgroups: sci.electronics
Path: arc1-ca.pugleaf.net!sparky!uunet!wupost!calvin.sbc.com!tadams
From: tadams@sbctri.sbc.com (Tom. Adams 529-7860)
Subject: EPROM programming info.
Message-ID: <1993Jan8.144544.4162@sbctri.sbc.com>
Organization: Southwestern Bell Technology Resources, St.Louis, MO
Date: Fri, 8 Jan 93 14:45:44 GMT
Lines: 15