computer control of stepper motors

Article View: sci.electronics

Article #16867

#16867

From: Curt Miller
Date: Wed, 27 Jan 1993 03:13

20 lines
1396 bytes

	I was wondering if anyone could please point me to some good
articles, magazines, or books that would deal with the topic of controling
stepper motors with a computer, preferably a MSDOS based PC compatable
type system.  I am looking for hardware configurations and software 
drivers.  Any help would be appreciated.

	Please mail replies to the address listsed below, since 
	the site I currently read news at is temp. having problems.
	I will forward any responces to any interested parties.

UCSKJM@UCS.UWPLATT.EDU		Kurt Miller
UCSKJM@UWPLATT.BITNET	Univ. of Wisconsin Platteville
 


--
   The opinions expressed are not necessarily those of the University of
     North Carolina at Chapel Hill, the Campus Office for Information
        Technology, or the Experimental Bulletin Board Service.
           internet:  laUNChpad.unc.edu or 152.2.22.80

Technical Details

Message-ID: <1993Jan27.031343.3356@samba.oit.unc.edu>

Path:

arc1-ca.pugleaf.net!sparky!uunet!charon.amdahl.com!pacbell.com!decwrl!elroy.jpl.nasa.gov!swrinde!zaphod.mps.ohio-state.edu!rpi!gatech!concert!samba!usenet

Show Full Headers

Complete Article Headers

Newsgroups: sci.electronics
Path: arc1-ca.pugleaf.net!sparky!uunet!charon.amdahl.com!pacbell.com!decwrl!elroy.jpl.nasa.gov!swrinde!zaphod.mps.ohio-state.edu!rpi!gatech!concert!samba!usenet
From: Curt.Miller@launchpad.unc.edu (Curt Miller)
Subject: computer control of stepper motors
Message-ID: <1993Jan27.031343.3356@samba.oit.unc.edu>
Sender: usenet@samba.oit.unc.edu
Nntp-Posting-Host: lambada.oit.unc.edu
Organization: University of North Carolina Extended Bulletin Board Service
Date: Wed, 27 Jan 1993 03:13:43 GMT
Lines: 20