🚀 go-pugleaf

Hello.  I have a application which requires a VERY small transmitter
and reciever onto a single frequency.  My requirements are:

	Power:  Very low, 100 feet line of sight
	Frequency:  Any, (legal that is), antenna must be wire under 6"
	Size:	UNDER 1" by 1", BUT I plan to make it into a custom
		Analog chip, so this is not a major problem.
	Data:	Over 50kbits per sec on 6 channels (Data only on one
		channel at a time, see note below.)

	Basically I need three versions of the tranciever.
	There are 6 channels, I will call them ABCDEF

	Number 1:  Transmitt A, B
	Number 2:  Transmitt C, D,  Receive A,B,C,D
	Number 3:  Transmitt E, F,  Receive C, D
	Only number three needs to be the smallest.

Obviously, I plan to breadboard this first, then we will see about making
it microscopic.  Any help would be appreciated.

___________________________________________________________________________
Wilson P. Snyder II		beowulf!lunge!snyderw@steinmez.UUCP
318 Crockett Hall, RPI		(uunet!steinmez!bewulf!lunge!snyderw)
Troy, NY 12180





______________________________________________________________________
Wilson P. Snyder II		beowulf!lunge!snyderw@steinmez.UUCP
318 Crockett Hall, RPI		(uunet!steinmez!bewulf!lunge!snyderw)
Troy, NY 12180-3590		518-276-2764, 802-658-3799 in summer
______________________________________________________________________