Re: X10 Questions

Article View: sci.electronics

Article #19145

#19145

From: Paul Milazzo
Date: Sun, 08 May 1988 17:08

20 lines
1421 bytes

In article <52412@sun.uucp> dcj@sun.uucp (Don Jackson) asks about
a BSR X10 interface for his sprinkler system; so far he has found only
valves activated by low-voltage DC, inappropriate for the X10 system.

I recently picked up two 120 VAC water valves at an electronics surplus
store.  The valves are labelled "DELTROL CONTROLS / MILWAUKEE WIS" on
one side, and what looks like "DSV-10" on the other.  The solenoid is
marked "120 VAC  HZ 50/60  30 WATTS".

These valves should work well with BSR appliance modules.  They have
exposed electrical contacts, so they must be properly housed.  They
also make a loud "THWOCK!" noise as they switch, but that's fine; I
only paid $4/each for them...

Like Don, I'm also interested in a better BSR thermostat control.  Any
ideas?

                                Paul G. Milazzo <milazzo@rice.EDU>
                                Dept. of Computer Science
                                Rice University, Houston, TX

Technical Details

Message-ID: <679@thalia.rice.edu>

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!husc6!rice!titan!milazzo

References: <52412@sun.uucp>

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!husc6!rice!titan!milazzo
From: milazzo@titan.rice.edu (Paul Milazzo)
Newsgroups: sci.electronics
Subject: Re: X10 Questions
Summary: Use 120 VAC water valves
Keywords: BSR X10 sprinkler controls
Message-ID: <679@thalia.rice.edu>
Date: 8 May 88 17:08:50 GMT
References: <52412@sun.uucp>
Sender: usenet@rice.edu
Reply-To: milazzo@rice.edu (Paul Milazzo)
Organization: Rice University, Houston
Lines: 20

Reply to Parent Message